The instructions are below:
1. Thoroughly
wash and dry glass vase and set aside.
2. Using
Create-a-Flake Three and Snowflake Pendant die templates, cut assorted
snowflakes from self adhesive vinyl.
Peel off protective backing from snowflakes and arrange on vase. With the back of a spoon, rub vinyl
snowflakes on vase until all air bubbles are removed. This is an important step to keep the etching
cream from seeping underneath the vinyl stencils.
3. Generously
apply the etching cream onto the vase with a foam brush. Don’t be afraid to use plenty of cream, as
you will be putting the excess back in the jar.
Wait 15 minutes for the glass to etch.
4. Use
a foam brush to remove excess cream and put back into jar, being careful not to
disturb the stencils. Once the excess
cream is removed, put vase into bucket of water and remove the cream from the
vase with a sponge. The stencils may
come off during this process but it is ok.
5. Make
sure all vinyl has been removed and rinse vase in sink with fresh water then
dry with a towel. The etching will
appear once your vase is dry.
6. Cut/emboss
the large snowflake from Create-a-Flake Three with white glitter paper. Add white pearl to center of snowflake.
8. Tie
a bow around the top edge of vase with a light blue ribbon. Tie snowflake and sentiment to silk ribbon
bow with white floss.